Compressor controllers that Airtag can establish a data link with

Compressor controllers that Airtag can establish a data link with

Brand

Controller

Note

Palatek

Q1, S1

 

IR

SE

interconnect X-IRI gateway between Airtag and the SE controller. DIP switches on the gateway must be correct for address (1), baudrate (9600), and stopbit (1)

XE90 (oil free two stage)

 

XE90 (R series, 1 stage)

 

XE145 (R series, 1 stage, Nirvana)

 

Danfoss

 

SG, SGN, SGNe

 

Gardner Denver

Delcos 3100

 

Delcos XL/Pilot TS

Standard Pilot TS controller has 1 RS485 serial comm port which uses the Modbus RTU protocol. If this port is already used (e.g. for CompAir gateway), quote sensor kit.  

Delcos Pro/Pilot

 

Governor

 

AirSmart G1/G2

 

Boge

Focus, Focus 2

 

Kaishan

MAM200

 

MAM6090

 

Sullair

Supervisor

Mirius gateway must be purchased at an additional cost in order to communicate with Airtag

STS V1/ STS Global

 

WS

 

Elgi

Neuron II, Neuron III, Neuron IV

 

 

Roger

Goat II

 

FS Curtis

iCommand

 

HERTZ

Logik 33s

 


    • Related Articles

    • Asset health page

      Airtag Health Page Introduction: The purpose of this article is to serve as an all-inclusive resource for understanding the features and information that are available through the Airmatics dashboard, specifically the 'Health' page. Each part of this ...
    • No Cellular / internet connectivity. No data is being displayed in Aircloud. AirTag is offline.

      This article describes which connectivity issues can occur, how they manifest themselves in practice, how they can be identified and investigated, and finally, what steps can be taken to resolve the problem. Description of the experienced issue No ...
    • When the AirTag loses communication with the cloud is the data displayed on Aircloud still accurate?

      Accuracy of data when communication with the cloud is lost: When the AirTag detects no communication with the cloud it will save the data samples locally. The processing of data is still as accurate as if it were to be connected to the cloud. In ...
    • What does an AirTag KIT include?

      An AirTag kit (Y15TICS43) contains the following items: AirTag module kit AirTag Connector terminal set AirTag installation kit Tag in-line fuse installation kit Fuses Fuse holders bootlace ferrules coding sleeves for the wires heat shrinkable ...
    • No data communication between asset controller and an AIR-TAG.

      It is possible for an AIR-TAG to obtain data from a compressor via a serial connection (RS485, Airbus485 protocol or ModbusRTU protocol). If your AIR-TAG is set-up for a data communication, but there is no data being displayed on the Aircloud ...