UniTag Single Stage, Positive Displacement, Installation manual

UniTag Single Stage, Positive Displacement, Installation manual

This document focuses on the installation of the UniTAG in an AirMatics installation.

In such installation there are always other components installed (AirTAGs and/or Metacentre). The installation of these components is not part of this document.

All sensors require a proper way of installation. Be sure these are installed according to the requirements.

    • Related Articles

    • AIR-TAG, Single stage, positive displacement installation guide

      This guide supports the physical installation of AIR-TAG to a single stage positive displacement host asset.

    • TAG Asset installation kit

      General parts and assemblies, TAG installation, single asset KB note:: The TAG module counter connector 'set' is available for separate purchase.  The sale of individual kit components is NOT supported

    • Configuring Multi-Stage Compressors

      In "Device Settings", in "Edit" do the following: A. Under "Sensor Configuration - Multi Stage": i. To enable TWO-STAGE Dashboard: "Enable Stage 1 Sensors" and "Enable Stage 2 Sensors". ii. To enable THREE-STAGE Dashboard: "Enable Stage 1 Sensors", ...

    • Airmatics AERO technical manual

      To download the manual, click this link.

    • Airmatics AERO ModbusRTU Quickstart Guide

      Access the Airmatics AERO Modbus RTU Quickstart Guide here. This guide provides all necessary details to read data over ModbusRTU on the Airmatics AERO product. It includes: Connection Setup: Where to connect to the Airmatics AERO product. ...