What does an AirTag KIT include?

What does an AirTag KIT include?

An AirTag kit (Y15TICS43) contains the following items:
  1. AirTag module kit
    1. AirTag
    2. Connector terminal set
  2. AirTag installation kit
    1. Tag in-line fuse installation kit
      1. Fuses
      2. Fuse holders
      3. bootlace ferrules
      4. coding sleeves for the wires
      5. heat shrinkable crimping sleeves
      6. hook-up conductor strand
    2. Tag power supply terminal kit
      1. Fuses
      2. Fuse holders
      3. WAGO
      4. WAGO marker cards
      5. WAGO end plate
      6. Carrier terminal block
      7. grippa bag 100x150 mm
    3. Tag Asset installation kit
      1. Bootlace ferrules for crimping
      2. Cable marker clip-on
      3. DIN-rail
      4. Screws
      5. Cable ties & holder
      6. Strip of foam tape with aluminum top layer
      7. Cables: 2.5mm² green/yellow, 1.0mm² Red, 1.0mm² Blue.
      8. VS box
      9. 1-component silicone
    4. DCO
  3. RS485 Data communication cable kit
    1. 2m cable for communication purposes
    2. Connectors
  4. Temperature sensor PT1000, measuring range: -50°C to 120°C, IP65 + 3m cable (2x0.35mm²)
  5. Current sensor, 200A/0.1A with silicone 5m cable
  6. Gateway 24VDC power supply cable

    • Related Articles

    • Compressor controllers that Airtag can establish a data link with

      Brand Controller Note Palatek Q1, S1 IR SE interconnect X-IRI gateway between Airtag and the SE controller. DIP switches on the gateway must be correct for address (1), baudrate (9600), and stopbit (1) XE90 (oil free two stage) XE90 (R series, 1 ...

    • Gateway kit, US

      Gateway module with power supply unit, network cable, puck antenna and DIN rail mount brace Setup and pre-installed with territory SIM KB note: Only supplied as a KIT.  Components parts are not available for individual purchase!

    • Gateway kit, EU

      Gateway module with power supply unit, network cable, puck antenna and DIN rail mount brace Setup and pre-installed with territory SIM KB note: Only supplied as a KIT.  Components parts are not available for individual purchase!

    • TAG Asset installation kit

      General parts and assemblies, TAG installation, single asset KB note:: The TAG module counter connector 'set' is available for separate purchase.  The sale of individual kit components is NOT supported

    • TAG, Power supply terminal kit

      DIN rail mount fused terminal assembly, L1 + N power supply, 2 x 1.0A fuse KB notes: The TAG Power supply terminal kit is available for purchase. The sale of individual kit component parts is NOT supported The sale of FUSES is NOT supported (observe ...